LOCTITE® FREKOTE® PMC

LOCTITE® FREKOTE® PMC is a post-cleaner with a special blend of solvents designed to dissolve and remove wax from polyester molds without dulling the surface. It can also be used to clean epoxy and metal mold surfaces, as well brushes and equipment. It is highly recommended for preparing polyester mold surfaces prior to the application of LOCTITE® FREKOTE® mold sealers and release agents.

Typical Properties of Uncured Material

Specific Gravity @ 25 °C	0.821 to 0.854^LMS
Flash Point	See SDS

Directions for Use

LOCTITE® Frekote PMC™ should be applied to the mold surface with a clean lint free cloth.
Wax and other mold residue will immediately begin to dissolve and should be removed from the surface with a second clean cloth while it is still dissolved in the LOCTITE® Frekote PMC™.
As the cloth becomes saturated with wax and mold residue, dispose of it and use a new cloth.
Repeat process until composite and other mold residue is removed.
The mold is now ready for use.
NOTE: A simple test to assess mold cleanliness is the use of masking tape. A coated surface will allow easy release of masking tape, where as a wax free surface will allow good adhesion of masking tape. This test can also be used to determine the effectiveness of Frekote® Release Interfaces. A good interface will prevent any significant degree of tape adhesion.