TYPICAL PROPERTIES OF UNCURED MATERIAL
Resin Properties
| Specific Gravity @ 25 °C | 0.745 to 0.775 LMS |
| Release Agent Transfer | ≥4LMS |
| Flash Point | See SDS |
Directions for Use
1. Loctite®Frekote® B-15™ can be applied to mold surfaces by spraying, brushing, dipping or wiping with a clean, lint free, cotton wiping cloth. When spraying, ensure a dry air source is used or use an airless spray system making sure the nozzles is 20 to 25 cm from the mold surface.
2. Brushing and dipping are effective methods of application,but care should be taken to avoid excessive pooling and to ensure that the part is well drained. Wiping on is the best method of application.
3. Only a thin wet film is required. It is suggested that small areas be coated, working progressively from one mold to the other.
4. Apply a minimum of two coats, allowing 30 minutes between coats.
5. The final coat will cure within 24 hours at 23°C or the cure process can be shortened by baking the mold for 60 minutes at 95°C after ensuring that the mold is dry and all sovents have flashed off.
6. The mold is now ready to be coated with Frekote mold release products. Please refer to individual product data sheets for the proper application of the release agent.
