TYPICAL PROPERTIES OF UNCURED MATERIAL
Resin Properties
| Weight per volume | 2.5 to 2.64kg/L |
| Flash Point | See SDS |
Hardener Properties
| Weight per volume | 1.5 to 1.54kg/L |
| Flash Point | See SDS |
TYPICAL PROPERTIES OF UNCURED MATERIAL
Resin Properties
| Gel Time @ 21 °C, minutes | 3.5 to 4 |
Application
1. Mix resin and hardener according to mix ratios listed or transfer entire kit onto a clean and dry mixing surface and mix material vigorously until a uniform color is obtained.
2. Apply material to prepared surface by first forcing a thin layer deep into the texture of the substrate.
3. Then Immediately build up to the desired finished thickness.
4. If using to rebuild shaft, the following applies:
● Machine the worn area down 3 mm (0.125 in) to produce a square shoulder on part. The material is stronger with a square edge versus a feathered edge.
● Machine a spiral cut in bottom of area to be repaired to provide mechanical keying into surface.
● Apply excess product to ensure small shrinkage during cure does not produce depression.
● Machine the surface to original dimensions prior to full cure, as the product is very wear resistant.
