TECHNICAL DATA(Typical Test Results)
PART A
| Base | Epoxy Resin |
| Colour | black |
| Density | approx. 1.0 g/ml |
| Viscosity | approx. 145 Pa.s |
| Measuring equipment | Physika UDS 200 |
| Measuring system | plate/plate Ø 20 mm |
| Shear rate | 10 s-1 |
| Temperature | 23 °C |
PART B
| Base | Amine |
| Colour | grey-green |
| Density | approx. 1.1 g/ml |
| Viscosity | approx. 75 Pa.s |
| Measuring equipment | Physika UDS 200 |
| Measuring system | plate/plate Ø 20 mm |
| Shear rate | 10 s-1 |
| Temperature | 23 °C |
| Mixing ratio A:B by volume | 1:1 |
Application Areas
It is special designed for bare steel, zinc coated steels and aluminum alloys used in the automotive industry or body repair shops, where high strenght and corrosion protection properties are required.
TEROSON EP 5055 is processed from universal cartridges with manual application tools (dispenser driven by hand, air pressure or battery). Only use dispensers that are equipped with a piston rod. Prior to screwing the static mixer, a small amount of the material should be pressed out to ensure that both components are passed on simultaneously. After mixing, the adhesive is ready for use and must be processed within 80 min, since viscosity increases when curing starts. In order to avoid the bonded parts being displaced, it is recommended that they should always be fixed during the process of curing. The processing time depends on the temperature.
