LOCTITE® SI 5910

Typical applications include stamped sheet metal covers(timing covers and oil sumps) where good oil resistance and the ability to withstand high joint-movement is required. The thixotropic nature of LOCTITE® SI 5910® reduces the migration of liquid product after application to the substrate.

TYPICAL PROPERTIES OF UNCURED MATERIAL

Specific Gravity @ 20 °C	1.34
Extrusion Rate, g/min: Pressure 0.62 MPa, time 15 seconds, temperature 25 °C: Semco Cartridge	300 to 650^LMS
Flash Point	See SDS

Directions for Use

1. For best performance bond surfaces should be clean and free from grease.
2. Moisture curing begins immediately after the product is exposed to the atmosphere, therefore parts to be assembled should be mated within a few minutes after the product is dispensed.
3. The bond should be allowed to cure (e.g. seven days),before subjecting to heavy service loads.
4. Excess material can be easily wiped away with non-polar solvents.