Typical Properties of Uncured Material
| Specific Gravity @ 25 °C | 0.71 to 0.73LMS |
| Flash Point | See SDS |
Directions for Use
- Apply LOCTITE® Frekote WOLO™ with a clean, lint free, cotton wiping cloth. Wet the cloth with LOCTITE® Frekote WOLO™ until it is damp but not dripping.
- Wipe a smooth, wet film over the entire mold surface. For larger molds, apply LOCTITE® Frekote WOLO™ to the surface one section at a time starting at one end and working towards the other. Continue to work the material into the mold by lightly wiping the wet film (10-30 seconds) until a thin and uniform coating is obtained, and then allow the product to evaporate.
- Allow a minimum of 5 minutes before applying next coat. Apply a minimum of four coats in this manner. Dampen cloth lightly as needed.
- Allow the final coat to cure for 15 minutes at 20°C.
- NOTE: If the cloth dries out during your coating process, use a fresh clean cloth to apply the next coat. This prevents resin accumulation on the cloth from being deposited on the mold surface. If streaking occurs, replace the cloth with a clean dry one and/or make sure that the cloth is just damp and not soaking wet. Avoid over-application, as this will cause streaking on the tooling surface. Streaks or wipe lines can be removed easily by wiping the mold surface lightly with a dry cloth. Product is moisture sensitive, keep container tightly closed when not in use.
- NOTE: For maximum number of releases, apply a touch up coat after the first 2-3 parts are released as a break in period after the initial application. On deep or high wear areas, apply an extra 1-2 coats of LOCTITE® Frekote WOLO™. This will help increase the slip even further in these high drag areas.
