Release System
Chemlease® 1365 EZ is a unique semi-permanent mold release system developed specifically for the composites industry, for use where a high quality finish is required.
| Supplier | |
|---|---|
| Industry | Adhesives, Automotive & Transportation, Building & Construction, Electrical & Electronics, HI&I Care, Home Renovation, Marine Vessels, Paints & Coatings, Petrochemical, Wind Energy |
| Additive Classification | Mold Release Agents |
• HAPs free*
• Multiple releases between applications
• Easy to apply
• Eliminates the use of wax
• Reduces labor time and costs
• Provides excellent gloss
• High temperature stability
• Does not build up on the mold surface
• Minimal transfer to molded part
1. Mold surface must be thoroughly cleaned to remove all traces of wax, release agents, and other sealers.
2. Surface should be dry and free of contaminants.
3. Saturate clean cotton cloth (not dripping) and wipe on a smooth continuous film. Apply no more than a few square feet at a time.
4. When the film begins to evaporate at the edge, wipe the surface with a second clean dry cotton cloth. Use a circular motion from the outside, working inwards until film is left dry and clear. See Notes.
5. Repeat above procedures until entire mold surface has been covered.
6. Apply 4-5 coats, allowing 15 minutes between each complete coat.
7. Allow 30 minutes for full cure. Proceed with production.
