Semi-Permanent Release Agent
Chemlease® PMR-90 EZ is a rapid curing semi-permanent mold release agent that provides multiple releases with minimal transfer to the molded part.
Chemlease® PMR-90 EZ is the highest slip version of the Chemlease® PMR family; primarily for closed molding of abrasive or low draft parts.
| Supplier | |
|---|---|
| Industry | Adhesives, Automotive & Transportation, Building & Construction, Electrical & Electronics, HI&I Care, Home Renovation, Marine Vessels, Paints & Coatings, Petrochemical, Wind Energy |
| Additive Classification | Mold Release Agents |
• HAPs Free*
• High thermal stability
• Easy to apply
• Multiple releases between applications.
• Reduces labor time and cost
1. Mold surface must be thoroughly cleaned to remove all traces of wax, release agents, and other sealers.
2. Surface should be dry and free of contaminants.
3. Saturate clean cotton cloth (not dripping) and wipe on a smooth continuous film. Apply no more than a few square feet at a time.
4. When the film begins to evaporate at the edge, wipe the surface with a second clean dry cotton cloth. Use a circular motion from the outside, working inwards until film is left dry and clear. See Notes.
5. Repeat above procedures until entire mold surface has been covered.
6. Apply 4-5 coats, allowing 15 minutes between each complete coat.
7. Allow 30 minutes for full cure. Proceed with production.
