Products Brand | |
---|---|
Additive Classification | Mold Release Agents |
Industry | Automotive & Transportation, Building & Construction, Electrical & Electronics, Home Renovation, Marine Vessels |
Technology | Mold Release |
Appearance | Clear, colorless |
Chemical Type | Solvent Based Polymer |
Odor | Hydrocarbon |
Cure | Room temperature cure |
Cured Thermal Stability | ≤400 °C |
Application | Release Coatings |
Application Temperature | 13 to 41 °C |
Specific Benefits | ● High gloss finish ● Easy application ● Fast curing ● Multiple releases ● Minimal mold build-up |
1. Apply LOCTITE® Frekote WOLO™ with a clean, lint free, cotton wiping cloth. Wet the cloth with LOCTITE® Frekote WOLO™ until it is damp but not dripping.
2. Wipe a smooth, wet film over the entire mold surface. For larger molds, apply LOCTITE® Frekote WOLO™ to the surface one section at a time starting at one end and working towards the other. Continue to work the material into the mold by lightly wiping the wet film (10-30 seconds) until a thin and uniform coating is obtained, and then allow the product to evaporate.
3. Allow a minimum of 5 minutes before applying next coat. Apply a minimum of four coats in this manner. Dampen cloth lightly as needed.
4. Allow the final coat to cure for 15 minutes at 20°C.
5. NOTE: If the cloth dries out during your coating process, use a fresh clean cloth to apply the next coat. This prevents resin accumulation on the cloth from being deposited on the mold surface. If streaking occurs, replace the cloth with a clean dry one and/or make sure that the cloth is just damp and not soaking wet. Avoid over-application, as this will cause streaking on the tooling surface. Streaks or wipe lines can be removed easily by wiping the mold surface lightly with a dry cloth. Product is moisture sensitive, keep container tightly closed when not in use.
6. NOTE: For maximum number of releases, apply a touch up coat after the first 2-3 parts are released as a break in period after the initial application. On deep or high wear areas, apply an extra 1-2 coats of LOCTITE® Frekote WOLO™. This will help increase the slip even further in these high drag areas.
Appearance:Light yellow transparent viscous liquid
Acid Value:14-20mgKOH/g
Viscosity,25℃:0.14-0.16Pa.s
Solid Content:52-58%
Gel time:25-38min
Physical State: Liquid
Epoxy Equivalent (g/eq): 176–184
Color (Gardner): Max 1.0
Flash Point (℃): Above 150
Viscosity (cps, at 25℃): 8000–11000
Hydrolyzable Chlorine Content (ppm): Below 1000
Specific Gravity (g/cm³, 25℃): 1.16
High tensile strength, allowing for use in hand lay-up process to produce large-area parts,
no airborne fiber when operating, good wet-through and fast wet-out in resins, rapid air
lease, high mechanical strength, superior acid corrosion resistance
True high-gloss paste wax.
Withstands high-temperature exothermic reactions of resins and does multiple releases easily.
Contains carnauba wax, synthetic waxes and high-temperature resistant resins for effective multiple releases of plastic parts through numerous cycles.
Brand:Trigonox®
Chemical family:Organic peroxide
CAS number:37206-20-5
Physical form:Liquid
Chemical name:Methyl isobutyl ketone peroxide
Brand:Perkadox®
Chemical family:Organic peroxide
CAS number:94-36-0
Physical form:Granular powder
Chemical name:Dibenzoyl peroxide
Fill out the form below, and we will be in touch shortly.